Cub Cadet 1811

The Cub Cadet 1811 is a tractor produced by Cub Cadet Lawn Tractors. It is equipped with a 691 cc 42.18 ci engine. The listed engine power is Gasoline (gross): 18 hp / 13.4 kW. Transmission: infinite forward and reverse.

Engine Power
Gasoline (gross): 18 hp / 13.4 kW
Fuel & Capacities
4 gal 15.1 L
Transmission
infinite forward and reverse

Overview

Cub Cadet 1811 tractor photo
1986 - 1989 Garden tractor
Production
Manufacturer
Cub Cadet (a part of MTD)
Garden tractor
Built in Brownsville, Tennessee, USA
Variants
1806
gear drive
1810
hydrostatic
1811
hydro with hydraulic lift
1812
hydro with lift and remotes
Cub Cadet 1811 Engine
18HP Kohler 691cc 2-cyl gasoline
Fuel tank
4 gal 15.1 L
Engine details ...
Cub Cadet 1811 Transmission
hydrostatic
Transmission details ...
Mechanical
Two-wheel drive
Manual steering
Dual disc brakes
Open operator station.
Tractor hitch
Rear Type
0 OptOptional
Power Take-off (PTO)
Front PTO
independent
Clutch
electric
Dimensions & Tires
Wheelbase
44 inches 111 cm
Front tire
16x6.50-8
Rear tire
23x10.50-12
Full dimensions and tires ...
Electrical
Ground
negative
Charging system
alternator
Charging amps
15
Battery volts
12
References
1811 references literature
Garden Tractors published in 1987, by Cub Cadet
Cub Cadet Garden Tractors published in 1988
Cub Cadet Garden Tractors published in 1989

Engine

Engine Detail — 691 cc / 42.18 ci Gasoline

Manufacturer
Kohler M18
Fuel Type
Gasoline
Configuration
2-cylinder, air-cooled
Displacement
691 cc 42.18 ci
Bore/Stroke
3.125x2.75 inches 79 x 70 mm
Power (gross)
18 hp 13.4 kW
Idle RPM
1200-3600
Starter
electric
Starter volts
12
Sparkplug gap
0.25 inches 6.350 mm
Intake valve clearance
0.004 inches (cold) 0.102 mm
Exhaust valve clearance
0.012 inches (cold) 0.305 mm
Oil capacity
2 qts 1.9 L

Transmission

Transmission — infinite forward and reverse shaft-driven hydrostatic

Type
shaft-driven hydrostatic
Gears
infinite forward and reverse
Oil capacity
7 qts 6.6 L
1811  shaft-driven hydrostatic speeds

Dimensions

Cub Cadet 1811 Tires
Lawn/turf front
16x6.50-8
Lawn/turf rear
23x10.50-12
Dimensions
Wheelbase
44 inches 111 cm
Length
72 inches 182 cm
Width
37.75 inches 95 cm
Height (steering wheel)
43 inches 109 cm
Ground clearance
6 inches 15 cm
Front tread
29 inches 73 cm
Rear tread
27 inches 68 cm

Attachments

Attachment overview
38" mid-mount mower deck
44" mid-mount mower deck
50" mid-mount mower deck
Snowblower
Blade
Garden tractors are capable of using tillers, plows, or other ground-engaging attachments. TractorData does not list details of these attachments.

Photos

Cub Cadet 1811 with mower deck.

Cub Cadet 1811 with mower deck.

Cub Cadet 1811 with front blade.

Cub Cadet 1811 with front blade.

Recommended Implements & Sizing Guide

Engineering recommendations for Cub Cadet Lawn Tractors Cub Cadet 1811 based on its 18 HP power envelope and ASAE agricultural standards.

Implement & OperationRecommended SizeWorkload RatingEngineering Notes
Moldboard PlowPrimary Tillage
1 to 2 Bottom (12")1 - 2 铧 (30 cm)Light DutyIdeal for garden plots and light sandy soil.
Rotary Cutter / MowerMowing & Clearing
4 ft (48 in)1.2 mLight DutyPasture clipping and light brush under 1" diameter.
Rotary TillerSeedbed Prep
42 to 48 in105 - 120 cmLight DutyCovers compact tractor tire width.
Sizing & Soil Condition NoteActual implement sizing varies depending on local soil conditions (heavy clay vs sandy loam), field slope, and operating speed. Heavy tillage implements may require front ballast weights and wheel weights.

Fluids, Capacities & Working Autonomy

Standard fluid requirements, service intervals, and continuous runtime estimates for Cub Cadet Lawn Tractors Cub Cadet 1811.

Estimated Continuous Field Runtime: 4.3 hrs

Approximately 4.3 hours of continuous field operation at ~75% rated power on a full tank (4 gal / 15.1 L).

Estimated 75% Load Fuel Burn~0.9 gal/hr (3.5 L/hr)

Engine Crankcase Oil

SAE 15W-40 (Heavy Duty Diesel)
Standard Spec: API CK-4 / CJ-4 Heavy Duty
Service Interval: 150 – 250 Hours

Transmission & Hydraulic System

UTTO (Universal Tractor Transmission Oil)
Standard Spec: ISO VG 46 / 68 (Wet Brake & Trans Compatible)
Service Interval: 600 – 1000 Hours

Engine Cooling System

50/50 Ethylene Glycol Pre-mix
Standard Spec: ASTM D6210 / Heavy-Duty OAT Antifreeze
Service Interval: 2 Years / 1500 Hours

Cub Cadet Lawn Tractors Cub Cadet 1811 Specification Unit Converter

Convert power, fluid capacities, and operating weights between metric and imperial standards for Cub Cadet Lawn Tractors Cub Cadet 1811.

Converted Equivalents:

Horsepower (HP)18 hp
Kilowatts (kW)13.4 kW
Metric Horsepower (PS / CV)18.2 PS

Direct Competitor Comparison

Compare Cub Cadet 1811 against same-era industry alternatives in the same horsepower class.

Current Model
Cub Cadet Lawn Tractors

Cub Cadet 1811

Engine Power:Gasoline (gross): 18 hp / 13.4 kW
★ Baseline Reference
KubotaMarket Competitor

Kubota B72

Engine Power:16.2
Production Years:1998 - 2001
Massey FergusonMarket Competitor

Massey Ferguson 1120

Engine Power:16.6
Production Years:1993 - 1996
International HarvesterMarket Competitor

International Harvester Type A 15HP

Engine Power:16.7
Production Years:1908 - 1911
MitsubishiMarket Competitor

Mitsubishi GF17

Engine Power:16.2
Production Years:2004 - 2005